STUD MOUNTING FOR THQ & THS SERIES HYBRID CAPACITORS

Threaded mounting studs for THQ & THS Hybrid Capacitors are now available welded directly to the leaded end of the case.  These studs, suitable for insertion into pre-drilled circuit board, provide rigid support and stability for Hybrid capacitor assembly. Studs are #2 -56 CDA 752, with several lengths available.  The Stud layout is centered on the positive lead, 90˚ to the negative lead, with 0.80" (Dim. 'B') spacing. Stud assembly withstands 50# pull test without failure or distortion of the case.    Studs are available on any rating THQ1, THQ3, THQ4, THQ5, or THS3 Series Hybrid Capacitors.

Part Numbers: see chart below

Pricing -
add $25 per unit for stud mounts for orders up to 500 units  
add $15 per unit for stud mounts on orders over 500 units

Stud Layout Drawing & mounting instructions

PWB layout for holes

Return to Hybrid Ratings and Specifications

Return To Hybrid Product Page

Refer to "Quick Refeference Guide"